Ipamorelin 2000mcg/ml Injection
Dosage Guide
INDICATIVE DOSAGE: 0.2ml-0.4ml Daily
5 out of 7 days a week
ADMINISTRATION PROTOCOL
- With provided alcohol wipe, wipe down the rubber part of the vial.
- Remove protective cover and stopper from the needle.
- Draw the same amount of air into the syringe as required dosage amount.
- Place needle into rubber part of bottle and push the plunger down to inject all the air. SEE IMAGE 1
- Turn the bottle and syringe upside-down. Be sure the needle is fully immersed before drawing back.
- Pull back on the plunger to required dosage (measure from the top of the plunger) SEE IMAGE 2
- Check syringe for air bubbles, tap the syringe so the air bubbles rise to the top and push up on the plunger to remove the air bubbles.
- Recheck the dose and add more to the syringe if necessary.
- Choose a site for injection and wipe clean with alcohol wipe.
- With your other hand, gently pinch a small fold of skin on either side of the cleaned injection site.
- Insert the needle fully into the pinched skin at a 90-degree angle (straight up and down) and slowly push on the plunger with your thumb until the bottom of the syringe is reached. SEE IMAGE 3
- Be sure to vary the exact injection side each time.
WHAT’S IN YOUR PACK
- 5ml Peptide vial(s)
- Alcohol Wipes
- Syringes
DOSAGE TIMING
Only inject when blood sugar levels are low (ideally no food an hour before or after injection).
These instructions are intended to be used as a guide only. We recommend following the directions given to you by your doctor if different from this guide.
INJECTION AREAS
- Abdomen – to the lower left or right side of your navel.
- Lower Back – below the waist but just above where the buttocks meet the lower back.
DISPOSAL OF NEEDLES
- Do not cap the needle. Drop the entire syringe and needle into your container for used “sharps” equipment.
- Do NOT put this container in the recycling bin. Check with your local health department for specific disposal instructions in your community.